ExtremeCloud IQ can update device firmware and reboot the device during
onboarding.
Use this task to configure Advanced Settings for an AP device
template.
-
Go to .
-
Select an existing AP
Template,and then select
, or select
.
-
Select the Advanced Settings tab.
-
For Upload device firmware upon
device authentication, turn the setting On to upgrade the
device firmware upon onboarding.
If you have activated device
firmware upgrading, select one of two options:
- Update firmware to the
latest version.
- Upgrade to a specific
device firmware version.
-
To Reboot after
uploading, turn the setting On.

Note
As a best practice, disable
the reboot option when deploying devices in a meshed environment.
-
For Antenna Location
Type, select a location from the drop-down list.

Note
You must have IQ Engine Version 10.2r2 or higher. The 6 GHz radio is
supported Low Power Indoor (LPI) only.

Note
Antenna Location Type does not apply to AP5020.

Note
A full config push is required as different radio tables are used.
-
To enable or disable Supplemental CLI,
see Configure Supplemental CLI.
-
Select a Country Code from
the menu.

Note
For Legacy World and EU SKU
devices, the template country code assignment only takes place when a device
is initially onboarded.
-
Enable Override MGT0 MTU
to manually enter a maximum transmission unit (MTU) value, ranging from 100-1500
Bytes. Default value is 1500 Bytes.
-
Enable POE Profile
Override (AP5010 only), and select the override option from the
menu.
Hover over the i to view the corresponding override table.
Finish configuring the device template.